- Sensing area: NTSC 4.08 x 3.10mm
- Effective Pixels: NTSC 795*596 pixels
- Horizontal Resolutions: 480 TV lines
- Minimum Illumination: 0lux with IR on
- Video output: RCA connector, 1.0V p-p, 75ohm
- Power Consumption: 60mA
- Power Supply: DC12V
Waterproof Level: IP68
This camera only supports NTSC video system, so please make sure your monitor supports NTSC video system before you buy it.
During installation, please connect the power cable of the backup camera to the harness wires that connect to the backup light on the tail light assembly.
The RED wire end is positive, while the BLACK one is negative. And connect the RCA output end to the car monitor.
The camera switch is controlled by the reverse gear shift.
Please take care of the sealing to prevent water leakage when installation.
Please Consult an experienced technician if you are not familiar with installing the Backup Camera.
WITHOUT the small "Allen Hex Key" tool Upgraded technology, get rid of "hex key", a so small tool that easy to be lost.
ONLY the generic suitable tool can be helpful for you to release the set screw on the camera and adjust the camera up and down for desired view angle.
1 X License Plate Frame Mount Rear View Camera
1 X 3.5ft Power Cable
1 X 20ft RCA Video Cable
1 X User Manual
*This backup camera is perfect for REAR,FRONT and SIDE VIEW. Monitor/LCD/Screen/Display/Radio is not included.
*When connecting this car backup camera to a FACTORY RADIO, a suited Harness & Programmer（not included because different RADIO need a different Harness & Programmer) will help you complete installation more efficiently.
*You can apply electrical tape for the joint of the red power wires and RCA wires, and use zip ties to fasten the wire on your vehicle.